Light Kit Assembly (Optional). Pgs - Craftmade Swyft Guia De Instalacion

9. Light Kit Assembly (Optional).
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing
female plug from motor housing to come
through hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that was
previously removed and securely tighten all 3
screws with a Phillips screwdriver.
If you wish to use the light kit, remove 1 screw
from underside of fitter plate and partially
loosen the other 2 screws.
Connect female plug from motor housing to
male plug from the LED light kit, matching up
the colors on the male plug with the colors on
the female plug for correct fit. Make sure that
plugs connect securely. [Note: If you will NOT
be using the light kit, do NOT connect the
plugs.] Carefully arrange wiring within the
back of LED light kit. Align slotted holes in
light kit fitter with loosened screws in fitter
plate. Twist light kit fitter to lock. Re-insert
screw that was previously removed and tighten
all 3 screws securely.
Locate slots on glass shade and align with
nodules on inside of LED light kit.
up on glass shade and turn
(clockwise) until it slides completely into place.
If you do NOT wish to use the light,
on metal cover and align with nodules on
inside of LED light kit. Gently push up on metal
cover and turn to the
slides completely into place.
CAUTION: Do not connect the LED light kit if
you do NOT wish to use the light.
Gently push
to the RIGHT
locate slots
RIGHT (clockwise) until it
motor plate
female plug
nodules
slots
nodules
slots
page 8
motor
housing
fitter
plate
female
plug
male
plug
LED light kit
glass shade
metal cover
motor
housing
LED light kit
LED light kit