Publicidad
Idiomas disponibles
Idiomas disponibles
5. Slide the hitch under the vehicle air dam. Raise into position to confirm
if additional flat washer are needed to use as spacer (due to vehicle
variants). If needed tape flat washers to forward attachment as needed,
both sides.
7. Tighten all 1/2 GR8 fasteners with torque wrench to 110 Lb.-Ft. (149
N*M)
Proper torque is needed to keep the hitch secure to the vehicle
when towing.
©2015 Cequent™ Performance Products, Inc. -
Printed in Mexico
6. Raise the hitch into position, feed the pull wires through the slots/holes on
the brackets. Pull the fasteners on the side, back through the frame and
bracket for support. Feed conical washer over pull wire, using the washer to
hold the bolt in place remove the pull wires and attach the hex nut. Tighten to
hold hitch in place, repeat on all fasteners. Note: if necessary use a screwdriver
to prevent the spacer from spinning. (due to vehicle variation some vehicle
have support plates that will prevent spacers from spinning) Repeat the same
process on both frame rails.
Sheet 5 of 15
65067NP
Teeth side
against hitch
04-21-15
Rev. E
Publicidad
