Pentair INTELLIBRITE 5G LIGHT Guía De Usuario página 19

INSTALLING THE INTELLIBRITE
GASKET AND UNI-TENSION WIRE CLAMP
Be sure to install ALL of the four retaining nuts. These nuts ensure proper electrical
ground. Failure to install all of the retaining nuts could create an electrical hazard
which could result in death or serious injury to pool users, installers or others due to
electrical shock.
Circuit board
connector plugs
Thermal
strip (2x)
1. Install NEW GASKET ONTO LENS: Stretch the gasket around the
circumference of the lens. Be sure the gasket is installed evenly around the
lens.
2. ALIGN LENS/GASKET ONTO LIGHT HOUSING:
a) With the light housing resting on its base, place the lens/gasket on top of the
light housing.
b) Rotate the lens/gasket to align the letter "W" ("WIDE" angle) on the lens with
the brass nut in the housing (see diagram on page 16 for brass nut location).
Note: The IntelliBrite light lens ships from the factory in the 'WIDE' (W) angle
position. The "wide" position of the lens is typically used for lights located either
side of the pool. The "narrow" position of the lens is typically used for lights
located either end of the pool. To use the "NARROW" angle light beam, rotate the
lens/gasket to align the letter "N" on lens. Note: For more information about the
"WIDE" and NARROW angle lens position, see page 18.
®
POOL LIGHT ASSEMBLY WITH NEW
INTELLIBRITE 5G Pool and Spa Lights Installation and User's Guide
®
Retaining nut (4x)
Circuit board
Light housing
Circuit board
stud (4x)
15