Coil at least
6.
This allows the light to be serviced on the deck after the pool is filled
with water.
7. Connect the three light wires to the corresponding light circuit wires in the
Junction Box. Connect the black wire to power, white wire to common,
and the green wire to ground. Secure the Junction Box cover.
8. Install the light assembly into the pool niche. IMPORTANT: Be sure to
insert the TAB on the lower part of the face ring into the niche SLOT
(located on the lower part of the niche). This is important to secure
the lower part of the light assembly onto the niche before tightening
the pilot screw.
9. Carefully tighten the special bronze pilot screw to secure the upper part
of the light assembly onto the niche.
10. Final check for proper IntelliBrite
main switch or circuit breaker to the system and the switch that operates
the IntelliBrite light itself. The light should illuminate when power is
applied. If not recheck the installation steps starting with Step 1 (page 3).
of cord around the light fixture (see page 8).
4 ft (1.22 m)
Pilot screw (bronze)
Face ring TAB
IntelliBrite Pool Light
INTELLIBRITE
(insert into
niche slot)
®
Light operation: Switch on the
5G Pool and Spa Lights Installation and User's Guide
®
17