Storage; Guarantee - Rothenberger PIPECUT TURBO 250 Instrucciones De Uso

composed of the gears, the racks and the guide shafts (Figure M/3), as well as the trapezoidal
screw (Figure M/4).
Disc guard
When you have been cutting plastic pipes and immediately afterwards you are going to cut metal
pipes, always clean the inside of the cutting disc guards. The hot particles warm will burn the
particles of plastic, or may release toxic fumes. As a rule, regularly clean the disc guard and pay
special attention to the movement of the movement of the cutting disc guard, to prevent it being
obstructed.
Motor
Keep the motor cooling holes clean.
Plastic parts
Clean the plastic parts with a soft cloth. Only use mild detergents. Do not use solvents or other
strong detergents.
Electrical cables
Regularly check the condition of the power cable. If the power cable is damaged, it must be
replaced by the authorised technical service. Correct use, assistance and regular cleaning will
ensure a long lifetime for our circular saw.
Environment
Separation of waste. Do not dispose of this product with normal domestic waste. When the useful
life of the circular saw has come to an end, do not dispose of it with domestic waste. This product
must be recycled separately. Separate recycling of used products and their packaging facilitates
the recycling and recovery of materials. Recycling these materials helps prevent environmental
pollution. According to the current legal regulations, appliances can be deposited at municipal
waste centres, at sites designed for this purpose or, delivered to the distributor when acquiring a
new product.
7

Storage

The circular pipe saw must be stored indoors, protected from impact, solar radiation, low
temperatures, dust, moisture and flooding.
8

Guarantee

If the pipe saw is out of service due to material or manufacture defects, within the first 24 months
after the purchase date, we will replace the damaged parts for new ones or provide a completely
new or factory-repaired saw to replace the damaged saw.
The guarantee is only valid if:
You send the guarantee leaflet or a receipt with the corresponding date to the manufacturer or
supplier.
You have used original accessories.
You have not used the saw incorrectly.
Unauthorised persons have not attempted to repair it.
The saw has been used in accordance with these operation, safety and maintenance instructions.
The guarantee does not apply to discs or guards exposed to overloads.
Due to the continuous improvement of the product, the information in this manual may be
modified. We do not provide express information of these amendments.
30 ENGLISH