Technical Data - OHAUS Ranger 7000 Manual Del Usuario

5. TECHNICAL DATA

The technical data is valid under the following conditions:

Indoor use only

Altitude: Up to 2000 m

Operating Temperature range: 5 ° C to 40 ° C.

Specified Temperature range: 10 ° C to 30 ° C (R71MHD3/6/15/35 models) -10 ° C to 40 ° C (R71MD3/6/15/35 models)

Humidity: maximum relative humidity 80 % for temperatures up to 30 ° C decreasing linearly to 50 % relative humidity at
40 ° C

Mains supply voltage fluctuations: up to ± 10 % of the nominal voltage

Installation category II

Pollution degree: 2
Specifications:
MODEL
Capacity
Readability d
Approved Readability e
Repeatability (std. dev.)
Linearity
Power supply
MODEL
Capacity
Readability d
Approved Readability e
Repeatability (std. dev.)
Linearity
Power supply
6. COMPLIANCE
Compliance to the following standards is indicated by the corresponding mark on the product.
Mark Standard
This product complies with the EU Directives 2014/30/EU (EMC), 2014/35/EU (LVD) and 2014/31/EU
(NAWI). The EU Declaration of Conformity is available online at www.ohaus.com/ce.
This product complies with the EU Directive 2002/96/EC (WEEE). Please dispose of this product in
accordance with local regulations at the collecting point specified for electrical and electronic equipment.
For disposal instructions in Europe, refer to www.ohaus.com/weee.
Verified weighing instruments
When the instrument is used in trade or a legally controlled application it must be set up, verified and sealed in accordance
with local weights and measures regulations. It is the responsibility of the purchaser to ensure that all pertinent legal
requirements are met.
Weighing Instruments verified at the place of manufacture bear the following supplementary metrology marking on the
descriptive plate.
Weighing Instruments to be verified in two stages have no supplementary metrology marking on the descriptive plate. The
second stage of conformity assessment must be carried out by the applicable weights and measures authorities.
If national regulations limit the validity period of the verification, the user of the weighing instrument must strictly observe the
re-verification period and inform the weights and measures authorities
As verification requirements vary by jurisdiction, the purchaser should contact their local weights and measures office if they
are not familiar with the requirements
R71MHD3 R71MHD6
3000 g
0.01 g
0.1 g
0.01 g
± 0.02 g
Power Input: 100-240 V~ 0.5 A 50/60 Hz
R71MD3 R71MD6
3000 g 6000 g
0.05 g 0.1 g
0.5 g 1 g
0.05 g 0.1 g
± 0.1 g ± 0.2 g
Power Input: 100-240 V~ 0.5 A 50/60 Hz
R71MHD15
6000 g 15000 g
0.02 g 0.1 g
0.2 g
0.02 g 0.1 g
± 0.04 g ± 0.2 g
R71MD15
15000 g
0.2 g
2 g
0.2 g
± 0.4 g
R71MHD35
35000 g
0.1 g
1 g 1 g
0.1 g
± 0.2 g
R71MD35 R71MD60
35000 g 60000 g
0.5 g
5 g
0.5 g
± 1 g
EN-5
1 g
10 g
1 g
± 2 g