Activating Code; Important; Led Light - Craftmade WSP70 Manual Del Usuario

9. Automated Learning Process./Activating Code.
REMOTE
CONTROL

LED LIGHT

FAN OFF
FAN SPEED
REVERSE
UP LIGHT
LIGHT KIT
12V
Install battery (provided) in transmitter and wall control (if applicable).
IMPORTANT: Store the transmitter away from excess heat or humidity. To prevent damage to transmitter,
remove the battery if not used for long periods.
LED LIGHT:
FAN SPEED, Buttons 1-6:
REVERSE:
LEARN button:
UP-LIGHT:
LIGHT KIT:
FAN OFF:
ON/OFF slider switch:
Select faceplate for remote control and/or wall control and press firmly onto front of remote control/wall
control.
IMPORTANT: The Automated Learning Process takes 5 minutes to complete. Please leave the fan "on"
for the duration of the 5-minute programming and do not use the remote control
during this time.
CAUTION: "DO NOT DISPOSE OF BATTERIES IN FIRE, BATTERIES MAY EXPLODE OR LEAK." - When disposing of
household alkaline batteries, it is best to check with your local and state recycling or household hazardous waste
coordinators concerning the specifics of the program in your area. You may also locate a recycling center by calling
1-800-8-BATTERY or 1-877-2-RECYCLE or visit www.epa.gov/epawaste/index.htm or www.earth911.org for more
information.
LEARN
3 4
5
2
1
6
LEARN
Comes on when any button is pressed.
Use to control the ceiling fan speed 1-6.
Use to control fan direction.
Turn fan power on. Within 30 seconds of powering fan,
press and hold LEARN button on remote control and/or wall
control for 5 seconds (or until fan beeps twice) in order to
synchronize remotes with fan motor.
Use for up-light (if applicable), or dimmer.
Use for light kit (if applicable), or dimmer.
Use to turn fan off.
[Wall control only] Use to turn wall control on or off.

IMPORTANT:

Remote and wall
controls must be
SYNC R ONI ED with
fan in order to
properly function.
page 8
WALL
CONTROL
LED LIGHT
3 4
2
5
1 6
12V
FAN OFF
FAN SPEED
REVERSE
UP LIGHT
LEARN
LIGHT KIT
ON/OFF
SLIDER
SWITCH
LEARN