Specifications; Glossary; Safety Precautions; Charging The Battery Pack - Merlin PILOT 500 Manual De Instrucciones

Specification

Glossary

Landing gear - Wheels on bottom of aeroplane
Vertical fin - Fin on back of aeroplane
Rudder - Moveable fin on vertical fin
Elevator - Moveable fins of the stabiliser
Fuselage - Main body of the aircraft containing motor, receiver, speed control, servos and battery
Stabiliser - Smaller flat wing on tail of aircraft

Safety Precautions

•
Read and follow this manual completely, observing all instructions and safety directions. Otherwise, serious injury and damage can occur.
Think about your safety, and the safety of others, first.
•
Hold the product securely when the flight battery is plugged in, keep the rotor away from body parts and clothing, even it isn't spinning, as
it could be turned on by accident. Beware of hair becoming entangled in the rotor.
•
Do not fly when it's too windy or you may lose control and crash, causing injury or damage. Never fly near people, vehicles, train tracks,
buildings, power lines, water, hard surfaces or trees. Never allow anyone to attempt to catch the model while it's in flight or serious injury
may result.
•
Adult supervision for flying and battery charging is recommended for pilots age 14 and younger.
•
Only use a battery charger that is compatible with the flight battery. Never leave the charger unattended while charging. This will help
prevent overcharging and make sure damage does not occur to the battery, charger or any other property. While charging, place the
battery on a heat-resistant surface. Do not lay it on carpet or upholstery while charging.
•
Never cut into the battery, charger, or aeroplane wires or serious injury may occur. Causing the battery to "short out" (crossing negative
and positive bare wires) can cause fire, serious injury and damage.
• When you finish flying your product, always unplug the battery before you turn off the transmitter.
•
Always check that the transmitter has full control of the model before flying.

Charging the battery pack

Use the supplied charger to charge the supplied battery. Other products are available and if used, you must follow the products instructions to
avoid damage.
The typical charge time for a flat battery is 45 minutes.
1. Connect the 240V wall mounted transformer (12V output) to the input side of the supplied charger, the red power indicator should glow.
2. Plug the battery into the 7.4V 2-cell output socket of the charger. The charge indicator should glow green to indicate charging is taking
place.
3. When charging is complete the charger will automatically stop charging and the charge indicator will go out.
4. Unplug the battery and input to the charger.
Cautions
•
Use the charger with adult supervision. Do not use the charger near water or when wet.
•
Do not use the charger if the wire is frayed or worn. If the wire is frayed or worn a short circuit can cause a fire or burns.
• If your battery gets hot and exceeds 50 degrees C during charge it may be faulty and you should contact your retailer
• If the battery pack bulges or expands during charge or use it is faulty and you should contact your retailer.
•
Never leave your battery pack on charge unattended.
Wingspan 500mm
Fuselage Length 396mm
Flying Weight 65g
Motor N50
Battery 7.4v 2 Cell 180mah Li-Polymer Battery
Flight Time Approx 15 minutes
Transmitter MTX-472 2.4GHz 4 Channel
Receiver / ESC / Servo MRX-521 4 in 1 Rx/ESC/Servo Unit
Charger 240v Balancing Battery Charger
2