STERWINS 40VLM2-42P.1 Instrucciones De Montaje, Utilización Y Mantenimiento página 288

• Operating similar tools nearby increases both the risk of hearing injury and the potential
FR
for other persons to enter your work area.
ES
• Keep firm footing and balance.
• Do not overreach. Overreaching can result in loss of balance. Always be sure of the
PT
footing on slopes.
• Walk, never run. Keep all parts of your body away from any moving part.
IT
• Never run the product without the proper equipment attached.
• Do not modify the product in any way or use parts and accessories that are not
EL
recommended by the manufacturer.
• After use, the tool must be left outdoors for at least two hours before entering inside a
PL
building
RU
KZ
UA
• To reduce the risk of injury associated with contacting rotating parts, always stop the
RO
machine, remove the battery pack and safety key, and make sure all moving parts have
stopped:
EN
- before cleaning or clearing a blockage
- when leaving the product unattended
- before installing or removing attachments
- before checking, maintaining or working on the product
- if the machine starts to vibrate abnormally (inspect immediately)
Removing and charging the battery : Illustration 6.1 and battery instruction manual
1. Press the lock button on the top center of the battery to slide it out of the product.
2. Place the battery pack into the charger by sliding it into a locked position until it clicks
3. When the green light is flashing, the battery is charging. If the green light is no longer flashing, the
battery is fully charged.
5. TRANSPORTATION
Transporting the machine or battery may require that you meet certain requirements specific to your
country. Please make sure to respect them by contacting the authorities of your country, in order to
respect them all. Ensure temperature during transportation will never be out of temperature range given
on chapter storage
5.1 TRANSPORT THE MACHINE
Illustration 6.1 to 6.8
Switch the product off and remove the battery pack and the safety key
If the product is dropped, suffers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service centre.
288