STERWINS 40VLM2-42P.1 Instrucciones De Montaje, Utilización Y Mantenimiento página 295

8.4 TROUBLESHOOTING
DANGER ! Risk of injury due to electric shock.
Warning ! Before any trouble shooting, switch off the product.
Problems
Product does
not start
Power/speed switch is in the
Battery pack not properly
On/off switch not set on ON
The panel bolts are not
The handle is
not correctly
fitted
The quick-fastening levers
The grass is not uniform or
The mower cuts
thick, or the cutting height
unevenly
was not correctly adjusted
Mulching is not The grass cuttings are damp
done correctly and sticking to the mower
The grass is long, the rear
panel of the mower and the
The mower is
blade are dragging in very
difficult to push
dense grass, or the cutting
The grass
cuttings are
The cutting height is too
not collected
properly in the
grass box
The blade is out of balance
The mower
vibrates at high
speed
The motor shaft is twisted
Probable causes
Battery is not secure
Battery is not charged
OFF position
attached
position
correctly inserted
are not tightened
height is set too low
low
or worn
Solutions
To secure the battery pack,
make sure the latches on the
top of the battery pack snap
into place
Charge the battery pack
according to the instructions
included with your model
Press the on/off switch
Attach properly
Refer to chapter "Start the
product"
Adjust the height of the handle
and check that the panel bolts
are correctly inserted
Tighten them
Check the height of the wheels.
All the wheels must be set to
the same cutting height so that
the mower can cut evenly
Wait for the lawn to dry before
mowing
Raise the cutting height
Raise the cutting height
Change the blade
Turn off the motor and inspect
the mower. Get the mower
repaired.
295
Qualification
required
-
-
-
-
-
-
-
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN