Electrical Connection - Elba P60 Instrucciones Para El Uso

N.B. For connections to the mains
power supply, never use adaptors,
reductions or multiple power points
as these may overheat and catch fire.
In the event that installation should requi-
re modifications to the mains supply
wiring system, it is recommended that a
qualified technician be called to carry out
substitution.
The technician will also have to verify
that the cross-section of the electric
cables on the power point match the
appliance's power rating.
If the hob surface is cracked discon-
nect the appliance from the mains.
1 2
D
C
Fig. 5.2
230 V
1 2
Fig. 5.3
26
3 4 5
C
50 Hz
3 4 5
PE
N L
1
(L )
2
Fig. 5.4

ELECTRICAL CONNECTION

To connect the mains flex to the hob,
proceed as follows:
Upturn the hob
Unscrew screws "A" and remove pro-
tection "B" (Fig. 5.4)
Insert connecting plates "C" into ter-
minal block "D" (Fig. 5.2) as shown in
the diagram in Fig. 5.3.
Unscrew cable clamp "E" (Fig. 5.4)
Insert correct section and type mains
flex (see special chapter) through
mains hitch "F" of protection "B," and
connect mains and earth wires to their
respective terminals in block "D," in
accordance with the diagram shown
in Fig. 5.3.
Tighten mains flex, and fix it with
clamp "E."
Replace protection "B," keeping flex
taut.
FEEDER SPECIAL CABLE SEC-
TION - Type "HO5V2V2-F"
resistance to temperatures of 90°C
230 VAC 50 Hz
A
F
D
2
3 x 2,50 mm
B
F
E