Docking Station; Reassembling Your Humid Aire 3I; Servicing - ResMed HumidAire 3i Manual Del Usuario

C
OVER AND COVER SEAL
Inspect the cover and cover seal weekly for wear and deterioration. Replace any
damaged parts. When required, wash the cover and cover seal in warm water, using a
mild detergent (see previous caution). Rinse them thoroughly with clean water and
allow them to dry away from direct sunlight.
D
OCKING
Periodically wipe the outside of the docking station (including the connector seal) with
a damp cloth.
R
EASSEMBLING YOUR
Please refer to the illustrations in section I of the illustration sheet.
Reassemble the parts when they are clean and dry.
1
Align the cover seal to the guides on the cover (I-1) and press along the edges to
ensure it is fitted properly (I-2).
2 Put one cover arm into its pivot point on the docking station (I-3) and gently flex the
other arm into its corresponding point (I-4 & I-5).
The cover should be able to open and close freely while securely attached to the

docking station.

3
Replace the water chamber in the humidifier docking station (I-6).
S
ERVICING
With normal use of a H
two years.
This product (H
Center 5 years from the date of manufacture. Prior to this, the device is intended to
provide safe and reliable operation provided that it is operated and maintained in
accordance with the instructions provided by ResMed. Applicable ResMed warranty
details are provided with the device at the time of original supply. Of course, as with
all electrical devices, if any irregularity becomes apparent, you should exercise caution
and have the device inspected by an authorized ResMed Service Center.
12
S
TATION
H A
UMID IRE
A
UMID IRE
A 3i) should be inspected by an authorized ResMed Service
UMID IRE
3i
3i, the water chamber needs to be replaced every