Mowox RM 600 Li BT Instrucciones De Funcionamiento Originales página 87

Robot cortacésped
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 188
robotic
mower
stopped in
the working
area
robotic
mower
stopped in
the working
area
robotic mower
tumbled and
stopped
The robotic
mower
stopped in tall
and rough
grass.
The robotic
mower
stopped and
the screen is
off.
Rev 7
Mower
The robotic mower is
trapped
trapped and stopped;
this occurs when the
collision sensor has
been triggered more
than 10 times within 1
minute.
Mower lifted
The robotic mower has
been lifted
continuously for ten
seconds.
Mower
The robotic mower has
rolling over
rolled over (upside
down) or lifted > 35%
Mower tilted
(20°).
Motor over-
The robotic mower
current
stopped because of
too high current in the
Motor Fault
motor.
Battery low
If the battery voltage
voltage
is too low and not on
the charging station,
the robotic mower will
stop and the display
will be blank.
1. Check if the robotic mower is
trapped by an obstacle or jammed
between trees bushes etc. Remove the
obstacle or avoid this area.
2. Check if the grass in the lawn is too
tall to block the Robotic mower on
moving. If so, please cut the grass to
less than 60 mm
3. Restart the robotic mower or take it
back to the charging station.
4. If this error message shows up
often, please check if the boundary
wire is correctly laid. Especially check
narrow corners, corridors, fences,
rocks, surrounding etc. Please change
the boundary wire layout.
Check if there are obstacles lower than
100 mm in the working area and, if
needed, move those out of the
working area or change the boundary
wire layout to exclude those.
1. If the roll-over is caused by too stiff
slopes in the working area, please
correct the boundary wire layout to
avoid those.
2. Take the robotic mower to a flat
area and restart it.
1. Check if too tall grass in the lawn
blocks the. If so, please cut the grass
to less than 60 mm using a
conventional mower.
2. Increase the cutting height.
3. Check if the blade disk is jammed. If
needed, clean.
4. Check if the wheels are jammed.
5. Restart the robotic mower or take it
back to the charging station.
Carry the robotic mower to the
station for charging.
40
(EN)

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido