Mowox RM 600 Li BT Instrucciones De Funcionamiento Originales página 90

The robotic
mower
behaves
abnormally
around islands
(flower beds,
pool, etc.).
The robotic
mower is
very noisy.
The robotic
mower stays
on the
station or the
mower keeps
going back to
the station.
The robot
operates
during rain.
If in doubt, bring your robot in for service.
Strictly follow the instructions of this manual. Faulty maintenance
or installation are not covered by the warranty
Rev 7
none boundary wire
incorrectly placed
around the islands
none 1. Damaged cutting
blades.
2. Cutting blade
flooded by residues
(tapes, ropes, plastic
fragments, etc)
3. The robotic mower
started with obstacles
being too close (less
than 1 m away - fallen
branches, forgotten
objects, etc.).
4. Damaged cutting
motor or driving motor.
5. Other damages on
the parts of the mower.
Wrong working time
none
setting.
The sensor measures
none
the resistance of the
surface, which can
change due to dirt.
Relocate the boundary wire.
1. Replace blades; the 3 blades need to
be changed at the same time.
The robotic mower's cutting
efficiency depends on sharp blades,
so please keep them in good
condition.
2. Stop the robotic Use gloves to
avoid any risk of injuries and remove
any residues from the blades.
3. Get the motor repaired or replaced
by the service station.
Check the working time setting.
Outside of the set working time
window, the robotic mower will hover
to the station and stay there.
This behaviour is also shown after
having given the "START" command
if outside the working time window!
Clean the rain sensor with a cloth
soaked in a detergent solution.
43 (EN)