Mowox RM 600 Li BT Instrucciones De Funcionamiento Originales página 89

Robot cortacésped
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 188
The battery
cannot be
charged.
The robotic
mower does
not boot.
Screen is off.
The robotic
mower cannot
enter the
charging
station.
The robotic
mower circles
around along
the boundary
wire.
The robotic
mower
stopped while
running back
to the station.
Rev 7
Charge error
Wrong contact of the
charging pins.
The battery has
reached its natural end
of life.
Hall error
There are metal parts
between the magnets
and the deck.
none
Hit the power key on
the keyboard for 3 sec.
to turn the LCD screen
on.
If the battery voltage
is too low, the LCD
screen cannot be
turned on.
Electric circuit or
electronic parts'
problem will also cause
this problem, if this
occurs, please contact
the service station.
none
If the charging station
is not installed
correctly, the robotic
mower cannot enter it.
None
High power cable close
to or underneath the
boundary wire affects
the boundary signal.
none
Objects on the
boundary wire blocked
the mower's
movement.
Please check it if the power source is
with problem, or clean the charging
pins if needed.
Replace the battery.
Take off the metal parts if needed.
Take appliance to a service dealer.
1. Make sure the main power switch is
"ON".
2. When you first use the robotic
mower the battery may not be fully
charged. Put the robotic mower into
its charging station.
3. Hit the power key on control panel,
then input PIN and start the robotic
mower.
4. If the screen is still off, please carry
the robotic mower to the charge
station. Make sure the main switch is
"ON"
5. Contact the service station.
1. Make sure the LED indicator on the
charging station is constant green.
2. Check if the boundary wire under
and in front of the charger are
aligned.
3. Check if the charging station is
positioned correctly.
4. Level off the charging station.
Check if there is a high-power cable
close to the boundary wire or
underneath it; change the position of
the boundary wire.
Remove any obstacle on the
boundary.
42
(EN)
for the battery to be charged.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido