Plumbing Requirements; Preparation; Anti-Tip Bracket - Sub-Zero IW-30 Guia De Instalacion

SI T E P R E PA R AT I ON

Plumbing Requirements

Installation must comply with all applicable plumbing codes.
For model IW-30CI, the water supply line should be located
within the shaded area shown in the illustration below.
The water supply line should be connected to the house
supply with an easily accessible shut-off valve. Do not use
self-piercing valves. The water supply line must be flush to
the floor and not interfere with the installation of the anti-tip
bracket.
A reverse osmosis system can be used provided there is
constant water pressure of 35–120 psi
to the unit at all times. In this application, the water filtra-
tion system must be bypassed. Refer to Water Filter Bypass
on page 15. A copper line is not recommended for this
application.
PL U M BIN G RE Q U IR EMEN T S
Water Supply Line
Water Pressure
Excess Water Line for Connection
WAT ER S U PPLY L OC ATI O N
IW-30CI
RIGHT SIDE
OF OPENING
A
6"
(152)
3"
(76)
AREA EXTENDS 1
/ "
2 (13)
FORWARD ON FLOOR
Water supply location (IW-30CI)
6 | Sub-Zero Customer Care 800.222.7820
supplied
(2.4–8.3 bar)
1 / " OD copper, braided
4
stainless steel, or PEX tubing
35–120 psi
(2.4–8.3 bar)
36"
(914)
A
6"
(152)

Preparation

Uncrate the unit and inspect for damage. Remove the wood
base and discard the shipping bolts and brackets. Remove
and recycle packing materials. Do not discard the kickplate,
anti-tip bracket, and hardware.
Remove the kickplate by extracting the two mounting
screws. Refer to the illustration below.

Anti-Tip Bracket

WARNING
To prevent the unit from tipping forward, the anti-tip
bracket must be installed.
The back of the anti-tip bracket must be installed 24"
from the front of the unit (without panels). Use all anti-tip
bracket hardware as instructed for wood or concrete floors.
For wood or concrete floor applications,
IMPORTANT NOTE:
if the #12 screws do not hit a wall stud or wall plate, use the
#8 screws and #12 washers with the wall anchors.
In some installations, the subflooring or
IMPORTANT NOTE:
finished floor may necessitate angling the screws used to
fasten the anti-tip bracket to the back wall.
SCREW
Kickplate removal
(610)