COZY CDV155DPPD Instrucciones De Instalación Y Funcionamiento página 23

STEP 15.
Check the inside of the housing for safety labels.
Try to avoid drilling through any pertinent safety
information during this step.
Use the base of the
PilotPro as a template
for the following steps.
Mount as directed or the
wire harness will not reach.
A
1. PLEASE NOTE
Align the PilotPro very close to the back edge of the housing.
Left
Side of
Heater
B
2. PLEASE NOTE
Be sure to face the notch / cutout of the base of the
PilotPro / Mounting plate (51) toward the wall.
3. Using the Mounting Plate (51) as a template, align
in place as illustrated. Using a marker or pencil,
leave a mark for the three hole locations on the
metal housing.
SET ASIDE THE MOUNTING PLATE ( 51 ) .
4.
NOT
DO DRILL DIRECTLY THROUGH MOUNTING PLATE.
DRILL MAY CRACK THE MOUNTING PLATE.
5. Drill the three holes into housing
using a 3/16" drill bit.
INSTALLATION
OF THIS STEP.
Right
Side of
Heater
OF THIS STEP.
A
Page 23
B
1019068-C