Installation - Teka LP2 400 Manual De Instrucciones

Installation

Positioning the appliance
Change the appliance in the desired location. The back should rest against the wall
behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is
equipped with water supply and drain hoses that can be positioned to the right or the
left to facilitate proper installation.
Levelling the appliance
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust
the dishwasher, making it level. In any case, the appliance should not be inclined more
than 2˚. If the appliance is levelled, it will help ensure proper performance.
Cold water connection
Connect the water supply hose to a threaded 3/4 (gas)
connector, making sure that it is fastened tightly in place
(see fi g.A).
Some models are fi tted with an "Aquastop" water supply
hose (see fig.B) in which the small filter is already
housed in the threaded end.
If the water pipes are new or have not been used for
an extended period of time, let the water run to make
sure that the water is clear and free of impurities. If this
precaution is not taken, there is a risk that the water
inlet can get blocked and damage the appliance.
Warning
The appliance is to be connected to the water mains using new hose-sets
and that old hose-sets should not be reused.
Anti-Flooding protection
If dishwasher is equipped with a system that stops the supply of water in the event
of a problem with the water supply hose, or leaks within the unit, in order to prevent
damage to your home. If for any reason the box containing the electrical components
happens to get damaged, remove the plug for the appliance from the socket
immediately. In order to guarantee that the anti-fl ooding feature operates properly, the
"A" box with water supply hose must be attached to the water supply tap as shown in
fi g.B. No other type of connection is acceptable.The water supply hose must not, under
any circumstances, be cut, as it contains electrical parts which are live. If the length
of the hose is not adequate to make a proper connection, the hose must be replaced
with one which is long enough. This hose is available upon request from specialised
retailers and service center.
4
en
fi g.A
fi g.B