Drain Hose Connection; Electrical Connection - Teka LP2 400 Manual De Instrucciones

Drain hose connection

Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into
the sink, making sure to avoid bending or crimping it. If necessary, fi t a syphon trap
(U-bend) with a connecting piece for the drain hose (fi g.C). The free end of the hose
must be at a height between 40 and 100 cm and must not be immersed in water.
Attention:
The connecting piece for syphon trap (U-bend) must be solidly fastened
to the wall to prevent the drain hose from moving and allowing water to
spill outside the drain.

Electrical Connection

After making sure that the voltage and frequency values for the current in the home
correspond to those on the rating plate (located on the stainless steel inner door of
the appliance) and that the electrical system is correct for the maximum voltage on
the rating plate, insert the plug into an electrical socket which is earthed properly (the
earthing of the appliance is a safety requirement mandated by law).
If the electrical socket to which the appliance must be connected is not appropriate for
the plug, replace the whole cable, rather than using adaptors or the similar like as they
could cause overheating and burns.
Caution:
The dishwasher plug must be accessible even when the appliance is
installed as a built-in unit so that maintenance can be done safely.
en
fi g.C
5