Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. Select "SYSTEM TEST".
NOTE: If unit has Error during system test, it may be
under charge.
Please refer "TROUBLESHOOTING" for your
corrective action.
6. Select "ON" to run the "SYSTEM TEST".
Press "DONE" to initiate test.
7. Allow the system test to run for its duration (10-15
minutes). "EQUIP TEST" screen will show the system
test is "ON" once selected.
System test will operate the heat pump and the indoor
unit through a series of startup tests.
Please proceed to the next step and allow for startup
tests to complete. Do not interrupt power to heat pump,
indoor unit, or thermostat during system test.
8. Press Previous Menu button and navigate to "HOME"
screen and allow test to finish. The display similar to
the one at the right will be displayed after "SYSTEM
TEST" completes. Test is complete only when "CODE
11" notice clears from BOTH the thermostat display
AND the seven segment LED display on the heat
pump. Please wait for test to complete and for both
codes to clear.
46
46
Publicidad
Tabla de contenido
