Replacing Components; Reminders For Replacing Components; Cleaning The Interior; Main Components - ALI PROXE70 Instrucciones Para Instalación, Uso Y Mantenimiento

Pilot burner goes out during use
Possible causes:
•
Insufficient gas supply pressure.
•
Defective gas tap or valve.
•
Defective thermocouple or insufficient heating.
•
Thermocouple incorrectly connected to gas tap or valve.
•
Knob of gas tap or valve not pressed sufficiently.
The main burner does not light (even though pilot is lit)
Possible causes:
•
Insufficient gas supply pressure.
•
Blocked tubing or nozzle.
•
Defective gas tap or valve.
•
Defective burner ( gas outlet holes clogged ).
Heating cannot be adjusted.
Possible causes:
•
Defective gas tap or gas valve.

16. REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS

•
After replacing a gas system component, check for gas
leaks at connection points.
GAS FRY-TOP
Replacing the gas tap / valve gas tap.
•
Remove the control panel.
•
Remove and replace the component.
•
Re-assemble all parts. For assembly, proceed in reverse
order.
Replacing the burner, the pilot burner, the
thermocouple, the piezoelectric ignition and the igniter.
•
Remove the control panel.
•
Remove and replace the component.
•
Re-assemble all parts. For assembly, proceed in reverse
order.
GAS FRY-TOP WITH TAP
Replacing the gas tap.
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Instructions for maintenance
Replacing the burner, the pilot burner, the thermocouple,
the piezoelectric ignition and the igniter.
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
GAS FRY-TOP WITH VALVE
Replacing the gas valve and safety thermostat.
• Remove the control panel.
• Remove the bulb from its seat on the bottom of the hotplate.
• Remove and replace the component.
• Insert the bulb properly in its seat on the bottom of the hotpla-
te.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the burner, the pilot burner, the thermocouple,
the piezoelectric ignition and the igniter.
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.

17. CLEANING THE INTERIOR

•
Check the condition of the inside of the appliance.
•
Remove any built-up dirt.
•
Check and clean the fumes exhaust system.
18. MAIN COMPONENTS GAS FRY-TOP WITH TAP
•
Gas tap
•
Main burner
•
Pilot burner
•
Thermocouple
•
Igniter
•
Piezoelectric ignition
•
Safety thermostat
GAS FRY-TOP WITH VALVE
• Gas valve
• Main burner
• Pilot burner
• Thermocouple
• Igniter
• Piezoelectric ignition
• Safety thermostat
29