V2 FORTECO 2500-I Manual Del Usuario página 67

Photocell 2 input
This menu allows enabling the input for type 2 photocells, that is to say,
photocells non active during the opening phase (see Chapter 4.4).
no Input disabled (ignored by the control unit).
No jumper with the common is required.
CF.Ch Input enabled even at standstill gate too: the opening
movement does not start if photocell is interrupted.
Ch Input enabled for the closing phase only.
Warning: if you select this option, you must disable
photocell test.
Test of the photocells
In order to achieve a safer operation for the user, the unit performs a
photocells operational test, before a normal working cycle.
If no operational faults are found, the gate starts moving.
Otherwise, it will stand still and the flashing light will stay onfor 5 sec.
The whole test cycle lasts less than one second.
WARNING: V2 suggests to keep activated the test of the
photocells in order to grant a higher safety of the system.
Safety ribbon 1 input
This menu allows enabling the input for type 1 safety ribbon, that is to
say, fixed ribbons (see Chapter 4.5).
no input disabled (ignored by the control unit).
AP Input enabled during the opening and disabled during the
closure
APCH Input enabled in opening and closure
Safety ribbon 2 input
This menu allows enabling the input for type 2 safety ribbon, that is to
say mobile ribbons (see Chapter 4.5).
no input disabled (ignored by the control unit).
No jumper with the common is required.
Ch Input enabled during closure and disabled during opening
APCH Input enabled in opening and closure
65