Migatronic SIGMA GALAXY 300 Guía De Usuario página 13

Connection and operation
Switch on, press, weld
Welding program setting.
• Switch on the welding machine on the main switch (2)
• Select welding program
1
MENU
9
# /9
2
PROG
See program table
• Adjust the welding current and secondary parameters
Please read your quickguide
• The machine is now ready to weld
WARNING
When you activate the torch trigger,
there is voltage applied to the
welding wire/electrode.
Trolley with automatic mains voltage transition
(special equipment)
Machines supplied with autotransformer can be
connected to the following mains supplies:
3x230V, 3x400V, 3x440V og 3x500V.
Press the power switch (13) to turn on the
autotransformer (green indicator light). The built-in
energy saver function will automatically turn off the
welding machine after 40 minutes of inactivity. Press the
button (14) to turn on the machine again (red indicator
light).
The energy saver function can be permanently
disconnected by a Migatronic technician.
Software reading
•
•
•
Please read how this
•
should be selected on
•
your welding machine in
the quick guide. Select
•
the welding program
suitable for the welding
All connected wire feed units will be updated with the new software.
wire and shielding gas or
possible electrode in use. It is necessary to read software inside the new control unit by means of a
SD card, if the control unit has been exchanged.
The software can be downloaded from http://migatronic.com/login
Licence SW
If additional licences for programs or special functions have been bought,
then the MigaLic.dat files should be read by the machine in the same way
as SW-packages. Please remember to save a backup file.
The MigaLic.txt file contains information about machine licence number
and containing licences at the SD-card.
Various wire feed units
Set-up with MWF 41 Master (feeder i) and
Slave (feeder 1-2)
Press the torch trigger briefly to activate
the slave unit. The green LED will be turned
on. Use the master control panel to set all
parameters. Settings are saved automatically
until the slave unit is activated.
Please note that MWF 41 Slave and RWF
have identical functions.
If water-cooling is active, both master and
slave must be equipped with water-cooled
hoses.
Insert the SIGMA SD-card in the slide in
the right side of the machine.
Turn on the machine.
The display flashes shortly with six lines.
Wait until the set current is displayed.
Turn off the machine and remove the
SD card.
The machine is now ready for use.
Master
i
MENU MENU
15.
9 9
/9 /9
# #
0.0
i
MENU
15.0
9
/9 V
#
0.0 V
6.2 m/min 5.0 mm
125
A
Slave 1 Slave 2
1 2
MENU
15. 15.
9
/9
#
0.0 0.0
Use of
MWF 41 Master and Slave
13