Faucet Installation - Rena Ware UCU-500 EXTREME Uso Y Mantenimiento

1. INSTALLING THE
INTEGRATED FAUCET
• For single hole sink decks, follow the instructions under: A) SINGLE POST MOUNT

FAUCET INSTALLATION

• For 3 hole sink decks, follow the instructions under: B) DECK PLATE AND FAUCET
INSTALLATION
A) SINGLE POST MOUNT FAUCET INSTALLATION:
You will need two people for installation. DO NOT use the Deck Plate, plastic bottom plate,
screws, or wing nuts.
• Insert the faucet Supply Tubes (1A), Pullout Hose (1B), and the Data Cable (1C) through
center hole of sink.
• Position the Pullout Hose so that its end is above the ends of the Supply Tubes (see inset
diagram below). This will make the installation of the washers and lock nut much easier.
Note: Do not remove the thin protective plastic bag (1H).
• From underneath the sink, place large rubber gasket (1D), lock washer (1E) and large
brass nut (1F) over Supply Tubes (1A), Hose (1B), and Data Cable (1C).
• Thread loosely onto faucet shank (1G).
• Before you tighten any connections: To avoid cutting the Data Cable and disabling the
indicator lights, you must front-align the faucet so that "Rena Ware" is centered and the
spout and handle swing equally to the right and left.
• Once the faucet is aligned, have one person hold the faucet firmly in place while the other
person tightens the faucet to the sink. CAUTION: Adjusting the faucet after tightening
to the sink will cut the Data Cable.
• Tighten faucet firmly to sink. Thread Brass Connector (1I) onto Pullout Hose (1B) and
tighten.
Skip the next section and go directly to step 2 "WATER SUPPLY CONNECTIONS."
1H
1G
1D
1F
1B
1A
1I
4B
1E
4A
1C
EN
11