Rena Ware UCU-500 EXTREME Uso Y Mantenimiento página 13

INSTALLING THE INTEGRATED FAUCET USING DECK PLATE
You will need two people for installation.
• Insert the faucet Supply Tubes (4A) and Pullout Hose (4B), and Data Cable (4C) through
the optional Deck Plate.
• Position the Pullout Hose so that its end is above the ends of the Supply Tubes (see inset
diagram below). This will make the installation of the washers and lock nut much easier.
Note: Do not remove the thin protective plastic bag (4H).
• From underneath the sink, place large rubber gasket (4C), lock washer (4D) and large
brass nut (4E) over Supply Tubes (4A), Hose (4B), and Data Cable (4F).
• Thread loosely onto faucet shank (4G).
• BEFORE YOU TIGHTEN ANY CONNECTIONS: To avoid cutting the Data Cable
and disabling the indicator lights, you must front-align the faucet so that "Rena Ware" is
centered and the spout and handle swing equally to the right and left.
• Once the faucet is aligned, have one person hold the faucet firmly in place while the other
person tightens the faucet to the sink. CAUTION: Adjusting the faucet after tightening
to the sink will cut the Data Cable.
• Tighten faucet firmly to sink. Thread the connector (4I) onto Hose (4B) and tighten.
4H
4G
4D
4F
4B
4I
4E
4C
4A
4B
4A
13
EN