Rena Ware UCU-500 EXTREME Uso Y Mantenimiento página 25

1. INSTALLING THE SIDE
FAUCET
NOTE: If there is not already a hole to accommodate the side faucet, drill one 22 mm (.87")
in diameter through the sink deck.
a. Unscrew the nut at the base of the spout. Remove the nut and both the steel and the
rubber washers.
b. Insert the base of the spout through the hole in the sink deck, holding it centered in
the hole with the lights on the Data Collar facing the front of the sink, replace the
Rubber Washer (top) and the Steel Washer and tighten the Brass Retaining Nut from
underneath the sink.
2. WATER SUPPLY CONNECTIONS
NOTE: The orientation of the valve is only for reference. It may vary according to your
plumbing installation.
a. Disconnect the cold water supply line from the bottom of the existing faucet. And
thread the collar of the 3-way-diverter valve onto the faucet's Cold Water Inlet.
Line to your existing faucet
(Cold Water Inlet)
EN
25