Publicidad
Idiomas disponibles
Idiomas disponibles
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual inclu-
ding all text under subheadings therein before set up or use of this product.
WARNING
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Turn the Power Switch of the tool
to its "OFF" position and unplug the tool from its electrical outlet before assembling or making any adjust-
ments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly
Diagram near the end of this manual. Mounting Table Saw
If mounting onto a metal table stand:
1. Select a table stand which will support the weight of the Table Saw. Follow the table saw stand instruc-
tions for assembly. Tighten all connections, making sure the assembled table is secure and balanced.
2. Mount the Table Saw to the top of the assembled stand using four 3/8" bolts, eight 3/8" washers and
four 3/8" nuts.
If mounting onto a bench or other wooden surface:
1. Select four 3/8" bolts, eight 3/8" washers, and four 3/8" nuts* (not included). *Screws and washers may
be used instead, if desired.
2. Place the Table Saw where it will be mounted. Make a mark in the center of each of the 4 mounting
holes. Set the Saw aside.
3. WARNING! Before drilling the holes, make sure that there are no electric wires, cables, utility lines
or other obstructions in the area to be drilled.
4. Drill the holes straight down, large enough to allow your mounting hardware to fit.
5. Put the Saw in place and mount using the hardware mentioned above. Tighten all hardware securely
before use.
Installing Push Stick Brackets
1. Tilt saw on its side to access opening underneath the Housing (12) of the saw.
2. Use ST4.2x14 Screws (4) and Ø4 Flat Washers (3) to attach the Push Stick Clamps (13) and Push
Stick Blocks (14) to the side of the Table Saw. See Figure 2.
9
www.ELITETOOLS.co
Keep Working
Publicidad
