Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Install a dado insert (sold separately) if using a dado blade. This will allow for wide (dado) cuts.
5. When stacking dado blades, you should be familiar with safe work practices and follow the directions
of the blade manufacturer during dado cuts. Stacked dado blade thickness should not exceed 1/2".
Always make sure that all mating faces are clean and fee of sawdust and debris.
Installing Anti-Kickback Pawls
1. Pull out the Pawl Lock Pin (96). See Figure 13.
2. Set the Pawl Socket (101) onto the rear mounting hole on the top of the Riving Knife (88).
3. Pivot the Pawl Socket against the Riving Knife until the Pawl Knob snaps back into place.
Attaching Blade Guard
WARNING: TO PREVENT SERIOUS INJURY: Unplug the Table Saw before this procedure. BLADE
GUARD MUST BE INSTALLED BEFORE USE.
15
www.ELITETOOLS.co
Keep Working
Publicidad
