Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING! Do not attempt to use the fence and miter gauge at the same time.
1. The width of a cut is achieved by moving the Fence (121) to the right or left.
2. The Table Saw features a Graduated Scale on the front of the unit. The Scale's measurements are in
both inch and metric increments.
3. To adjust the position of the Fence, raise the Fence Handle and slide the Fence along the Work Table.
Once the position is adjusted, lower the Fence Handle to lock the Fence in place.
4. To adjust the Fence position using the workpiece and the Graduated Scale:
a. Place the workpiece against the Fence on the Table Saw.
b. Raise the Fence Handle to unlock the Fence and slide the workpiece and Fence together to the right
or left until the left side of the Fence Guide (112) aligns with the desired measurement on the Graduated
Scale.
c. Lock the Fence in place by lowering the Fence Handle (110).
Work Piece and Work Area Set Up
1. Designate a work area that is clean and well-lit. The work area must not allow access by children or
pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach the work area without creating a tripping hazard or
exposing the power cord to possible damage. The power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using a vise or clamps (not included) to prevent movement while working.
4. There must not be objects, such as utility lines, nearby that will present a hazard while working.
GENERAL OPERATING INSTRUCTIONS
WARNING
TO PREVENT SERIOUS INJURY:
DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED.
Moving guards must move freely and close instantly.
INSTALL GUARD BEFORE USE.
19
www.ELITETOOLS.co
Keep Working
Publicidad
