Menu Service Engineer (Access To Standby Mode) - Thermor AEROMAX SPLIT 2 Manual De Uso

Warnings
3.

Menu service engineer (Access to standby Mode)

Access MENU
(or quit Menu):
Defines the function mode (please refer to chapter USE).
Usage period: Shows the operation time of heat pump and electric heating
element.
Summary settings: Shows all settings saved by the water heater.
System statuses: Shows the statuses of the water heater's and the heat pump's
components (signal NZ, compressor fuse , status heat pump, release heat pump
for operation , heat pump mode, compressor speed, communication status invert-
er-card, status electric heating element, temperature sensors).
Software versions: Shows the program versions.
Facilitates installation settings
Lock:
Function mode and heating range are not accessible.
Hot water:
Heating times
Anti-Legionella
Advanced modes
Reset: Resets to default settings
Allows for checking the functions of heat pump, electric heating element and fan.
Heat pump mode hot: Starts the heat pump to heat up the water.
Heat pump mode cold: Starts the heat pump to cool the water. This mode allows
for returning the gas to the external aggregate.
Electric heating element: Activates the electric heating element.
Warranty
+
5 seconds
: Allows for defining the start release range for operating heat
pump and electric heating element (refer to chapter USE).
: Activates the cycles at 62 °C, 1 to 4 times a month.
:
Emergency mode
element will be switched on. The nominal temperature is fixed
at 65 °C. Heating outside the normal functional range is fea-
sible at any time.
: Allows to activate or not the support by the
Electric backup
electric booster. If it is disabled, the unit will not use the elec-
trical booster.
Use
Installer access
access to
advanced functions
Emergency mode, only the electric heating
Servicing
This menu
provides access
to the advanced
information, setting
and test functions.
19