Scope Of The Warranty - Thermor AEROMAX SPLIT 2 Manual De Uso

Warnings
1.

Scope of the Warranty

This warranty does not cover malfunctions due to:
Abnormal environmental conditions:
• Various damages caused by shocks or falls during handling after leaving the factory.
• Installing the appliance in a location subject to freezing or bad weather (moist, harsh
environment or poorly ventilated).
• Using water with hardness criteria as defined in DTU Plumbing 60-1 addendum 4 hot
water (chlorides, sulphates, calcium, resistivity and TAC).
• Water with a Th <8° f (total hardness)
• Water pressure above 0.5 MPa (5 bar).
• Power supply with significant surges (main supply, lightning...).
• Damages resulting from problems that could not be detected due to the choice of the
installation location (difficult access) and which could have been avoided by immedi-
ate repair of the appliance.
An installation that is not in compliance with regulations, standards and best prac-
tices, including:
• The safety unit was removed or not functioning (pressure reducing device, check
valve or valve, etc. placed upstream of the safety unit).
• No safety unit or incorrect installation of a new safety unit in compliance with the NF
EN 1487 standard, change of its calibration...
• No sleeves (cast iron, steel or insulating) on hot water connection pipes which could
lead to corrosion.
• Faulty electrical connection: not in compliance with NFC 15-100, improper ground-
ing, insufficient cable length, connection with flexible cables without metal ends, fail-
ure to comply with the wiring diagrams as recommended by the manufacturer.
• Turning on the power to the appliance before filling it (dry heating).
• Positioning the appliance not in compliance with the instructions in the operating
manual.
• External corrosion due to poor water tightness of the piping.
• Installation of a domestic hot water recirculation system.
• Incorrect settings.
• Cooling lines non-compliant with our recommendations (phases, length, or drop).
Improper maintenance:
• Abnormal scaling of heating components or safety units.
• No maintenance of the safety unit resulting in overpressure.
• No cleaning of the evaporator and condensate drainage.
• Alteration of the original equipment, without contacting the manufacturer or using
spare parts not referenced by the manufacturer.
4
Warranty
WARRANTY
Use Servicing