Adjusting The Thread Tension; Replacing The Needle - Singer Stitch Sew Quick Manual Del Usuario

Pass the thread over the tension control between two silver-coloured
3 ]
discs. (See Figure #11)
Pass the threader through the needle hole from the front to the back.
4 ]
Pass the thread through the eyelet of the threader.
5 ] Pull the threader from the end of the thread towards the hole of
the needle, from the back to the front. (See Figure #12) Remove the
threader.

ADJUSTING THE THREAD TENSION

If the stitch is too tight, slightly turn the tension control to the left.
1 ]
If the stitch is too loose, slightly turn the tension control to the right.
2 ]
ATTACHING A REGULAR THREAD CONE
Loosen the bobbin nut and remove the bobbin.
1 ]
Slide the thread cone to the extension shaft.
2 ]
Connect the extension shaft to the bobbin shaft.
3 ]

REPLACING THE NEEDLE

Loosen the set screw with a screwdriver and remove the old needle.
Always use a Singer
The needle should be attached with the correct side of the needle
shaft, making sure that it faces the front side of Stitch Sew Quick
(See Figure #14)
2020 90/14 needle.
®
(See Figure #10)
.
™