Using The Detachable Front Panel - ideus KZ8000 Manual De Usario E Instalación

2. DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan, Toyota, follow
this mounting instruction. Use the screw
holes marked T (Toyota), N (Nissan)
located on both sides of the unit to fasten
the unit to the factory radio mounting
brackets supplied with your vehicle.
Fasten the unit to the factory radio
mounting brackets. Align the screw holes
on the bracket with the screw holes on the
unit, and then tighten the screws (5x5mm)
on each side.
Note:
the outer trim ring, sleeve and the
metal strap are not used for method B
installation.
4 KZ8000

Using the detachable front panel

REMOVING AND PROTECTING
DETACHABLE FRONT PANEL
The front panel of the unit may be removed
as a theft deterrent. After removing the
front panel, use the case provided to keep
the front panel from getting damaged.
1 Press the OPEN
.
the front panel.
2 Grasp the right side of the front panel,
.
then gently push the front panel towards
the left side before pulling it out from the
unit.
3 Store the front panel in the protective
.
case provided for safe keeping.
protective case
front panel
TO ATTACH THE FRONT PANEL
Hold the right side of the front panel with the
plate facing down.
First attach the left side of the front panel to
the unit by inserting the hole into the left
holder.
Then slightly push it leftwards and attach
the right side hole into the right holder.
Finally push up the front panel.
button to flip down
Open button
front panel
2
1