Erasing Codes - Performance Tool W2976 El Manual Del Propietario

• The control module number, sequence of the DTCs, total number of codes
detected and type of codes (Generic or Manufacturer specific, Stored or Pending
codes) will be observed on the upper right hand corner of the display.
3) If more than one DTC is found, use SCROLL button, as necessary, until all the
codes have been shown up.
• If no codes are detected, a "No codes are stored in the module!" message displays on
the screen.
• If retrieved DTCs contain any manufacturer specific or enhanced codes, the
display indicates "Manufacturer Control".
4) Press ENTER/EXIT button to return
to previous menu.

Erasing Codes

CAUTION: Erasing the Diagnostic Trouble Codes may allow the code reader to delete not only the
codes from the vehicle's on-board computer, but also "Freeze Frame" data and manufacturer
enhanced data. Further, the I/M Readiness Monitor Status for all vehicle monitors is reset to Not
Ready or Not Complete status. Do not erase the codes before the system has been checked
completely by a technician.
• This function is performed with key on engine off (KOEO). Do not start the engine.
1) If you decide to erase the DTCs, use
SCROLL button to select Erase Codes from
Diagnostics Menu and press ENTER/EXIT button.
2) A warning message comes up asking for
your confirmation.
3) If you want to proceed with erasing the codes,
press ENTER/EXIT button to erase.
• If the codes are cleared successfully, an
"Erase Done!" message shows up.
• If the codes are not cleared, then an
"Erase Failure. Turn Key on with Engine off!" message displays.
4) Wait a few seconds or press any key to return to Diagnostic Menu.
• If you do wish to proceed to erase the codes, then press SCROLL button to select
NO and press ENTER/EXIT. A "Command Canceled" message shows up. Press any key
or wait a few seconds to return to Diagnostic Menu.
1 2
$09
P0115
==============================
Manufacturer control
Diagnostic Menu
============================2/6
1) Read Codes
u 2) Erase Codes
3) View Freeze Frame
4) I/M Readiness
Erase Codes
==============================
Erase trouble codes!
Are you sure?
YES NO
4/6
Other