Input Configuration - AVIRE Connex-02 Guia De Instalacion

9. Configuring Connex-02 on the Avire Hub
To configure the Connex-02 you will need to be in the device setup page. You can
enter the setup page by double clicking on the Connex-02 icon in the Building setup
and then clicking 'Access' which will bring up the parameter setup page for that device.
9.1 Parameters Group
The Parameters Group shows the list of the inputs
and outputs that can be configured. Additionally, the
user can see the System information and the option
to select the "Engineering Off Site" view as well.
Each item on the Parameter Group will show a
different view under the "Parameters" field. All 5
inputs have a similar view and the same number of
Parameters, this also applies to the 2 outputs.
The installer can connect an input to any lift signal
information such as lift in maintenance, out of
service signal, doors status signal or any other lift
related signal.
Bear in mind that any changes made to the Avire
Hub to configure Connex-02 only apply if the
'Program' button is pressed, otherwise any changes
are not stored in the device.

9.2 Input Configuration

All 5 inputs are identical to configure and can be configured the same way.
9.2.1 Monitoring Mode
The "Monitor Mode" allows the user to select the monitoring feature of the inputs. The
drop down menu shows 5 different option which when triggered on the Connex-02,
registers that as a lift status event on the Avire Hub`.
10