AVIRE Connex-02 Guia De Instalacion página 5

5.2 Outputs
There are 2 opto-isolated outputs. The relays can switch a maximum resistive
load of 30VDC at 350mA. The voltage drop across the relay is less than
1V when the load is on. Outputs can be configured as normally OPEN or
normally CLOSED using the Avire Hub (see section 9.3 for more details).
6. LED Indicator
LEDs on the side of Connex-02 show the status of each input, the outputs and other
functions. If any input is connected to a input and Connex-02 receives signal the LED's
light will be on. The LED indicator light will be ON when there is a voltage applied to the
corresponding input/output.
LED Label
1 CH1
2 CH2
3 CH3
4 CH4
5 CH5
6 OP1
7 OP2
8 TOS
9 RX
10 TX
11 OK Heartbeat flashes every 1 second
*The corresponding input LED 2 shows when the button is pressed and LED 8 shows the whether the
"Technician on site" mode is activated.
Function
Input 01
Input 02
Input 03
Input 04
Input 05
Output 01
Output 02
Technician on site*
CAN data RX
CAN data TX
when device is on
Active
ON
ON
ON
ON
ON
ON
ON
ON
Flash every 1
second
5