Installation; Introduction; Mounting; Mounting Considerations - RISCO Group WL T312 Instrucciones De Instalación

Introduction

RISCO Group's wireless PIR outdoor detector, Wireless WatchOUT, is a unique detector with signal
processing based on two Passive Infrared (PIR) correlated channels. The detector can
communicate with RISCO Group's ProSYS control panel or other RISCO Group's wireless
receivers.
The following instructions describe the installation of the Wireless WatchOUT. For detailed
information regarding installation, refer to the relevant receiver installation instructions.

Mounting

Mounting Considerations

Optional Height: 1m – 2.7m
(3'3"-8'9")
Typical Height: 2.2m (7'2")
Default Lens: Wide angle 12m (40') 90°
(RL300)
Note:
1. For low installations, below 1.7m (5'6") in which
pet immunity is required, use the supplied
RL300F lens (Low wall or fence installations).
2. The detector's pet immunity (height of an animal,
no weight limitation), is up to 70 cm (2'4"), when
installing the detector at 2.2m (7'2"). If the
installation is below the height mentioned above,
the Pet Immunity decreases accordingly; every
10 cm (4") decrease in installation height leads
to 10 cm (4") decrease in pet height immunity.
For installations with extensive vehicle traffic or targets beyond
the required detection range, it is recommended to tilt the
detector down.
Note:
Tilting the detector down may reduce the pet immunity
For optimum detection, select a
location that is likely to
intercept an intruder moving
across the coverage pattern at
a 45° trajectory.
4

Installation

1m - 2.7m
(3'3" - 8'9")
If possible, avoid pointing the detector to
moving objects (swaying trees, bushes etc.)
Ensure any objects do not obstruct the field of
view. Pay attention to growing trees or bushes,
plants with big moving leaves etc.
Installation Instructions
5m (16')
With moving objects
keep distance of
minimum 5 meters (16')
Out of
Detection Range