Installation Instructions; Main Features; Installation Kit - RISCO Group RK66S Instrucciones De Instalación

INTRODUCTION
The RISCO Seismic Detector is used for the protection against break-in attempts of
vaults, safes, reinforced concrete walls, steel armored cabinets and doors. The
seismic detector monitors the vibration and temperature of a specific surface and
will react to all known types of intruder attacks, such as sledge hammers, diamond
head drills, explosives, hydraulic pressure tools and thermal tools.
The detector can operate both as a regular relay detector connected to any control
panel, or as a BUS accessory when connected to RISCO Group's control panels
via the RS485 BUS, empowering it with unique remote control and diagnostic
capabilities.
The instructions set forth below describe the RISCO seismic detector in Stand
Alone & BUS mode. For BUS installation programming, see RISCO System
installation manuals

Main Features:

 Piezo sensor
 Low/High temperature detection
 Detection range up to 5 meters (16 feet) radius
 Tamper protection
 Anti drilling shield
 Remote sensitivity control
 Analogue signal output
 Bar graph LED indicator
 Remote self test
 Stand-alone or RISCO BUS connection

INSTALLATION KIT

Each kit includes:
Wall structure fastening sets:
Metallic structure fastening sets:

INSTALLATION INSTRUCTIONS

Expanding plugs M6 x 16
Flat head machining screw M6 X 16
Inner Tooth Washer M4
Pan Head Machining Screw M4 X 10
2