Mirabelle MIRLS2522WH Instrucciones De Instalación

Safety Glasses
Safety Glasses
Jig Saw Masking Tape
Jig Saw Masking Tape
Mirabelle Acrylic Laundry Sink
Installation Instructions
IMPORTANT INSTRUCTIONS - Read before you begin
Read all instructions carefully before beginning installation. Remove the sink from its original carton and inspect it for damage. Return the sink to its
protective carton until you are ready to place it into position in the countertop. Inspect your faucet hardware to insure that all components exist for a
successful installation as outlined in the faucet and/or hardware installation guide. Inspect the waste and supply lines and replace if necessary.
NUT
NUT
GASKET
GASKET
NUT
NUT
GASKET
GASKET
100% Silicone Sealant
100% Silicone Sealant
Paper Towels
Paper Towels
SELF RIMMING INSTALLATION
1. Position the sink UPSIDE DOWN in the desired location on the countertop. Verify the position and
desired fit while observing the front overhang that exists on all countertops.
2. With a pencil, trace a line (or apply a border of masking tape) around the outside edge of the sink on the
counter top.
3. Remove the sink from the countertop.
4. Measure in 3/4" and draw new lines inside the first sink outline just drawn (or taped).
5. Drill a pilot hole inside the line drawn in Step 4 to allow a starting point for the Jig saw.
6. Following the line drawn in Step 4, carefully cut out the countertop.
7. Temporarily position the sink in the countertop opening so the sink edges line up with the pencil line or
tape border to insure a successful fit.
8. Carefully remove the sink and clean the countertop and remove tape (if any).
9. Mount the faucet hardware on the sink following the manufacturer's instructions.
10. Install the drain in accordance with the manufacturers instructions using Plumbers Putty following the
manufacturer's instructions. Note: Silicone Sealant or any other sealants other than Plumbers Putty should
not be used as a replacement for Plumbers Putty. Apply a thin, continuous bead of 100% silicone sealant
to the underside outer perimeter of sink approximately 1/4" inside the perimeter and carefully position
the sink in the opening. Remember that the sink rests on a layer of silicone sealant, not dry fitted to the
countertop.
11. Verify that the sink has not moved out of position and immediately remove any excess sealant filling any
remaining voids as needed.
12. Allow the sealant to cure at least 1 hour before proceeding.
13. Install the garbage/waste disposer, if applicable, following manufacturer's instructions.
14. Connect the drain assembly.
15. Connect the faucet supply lines following the faucet manufacturer's instructions.
16. Carefully turn on the water supply lines, then turn faucet on and check faucet, drain, and drain assembly
for leaks to insure a completed successful installation of your new Mirabelle laundry sink.
UNDER COUNTER INSTALLATION
When planning to use a Mirabelle laundry sink in an under counter installation please check style and size
before authorizing cutting of the countertop. For under mounting to granite or marble or solid surface
materials, contact your granite-marble-solid surface fabricator for installation requirements and proper
fasteners. Under counter installation kits are available (PFUCCLIP).
FOR CUSTOMER SUPPORT PLEASE CALL: 1-800-221-3379
Pencil Plumbers Putty
Pencil Plumbers Putty
Regular & Phillips
Channel Locks Regular & Phillips
Screwdriver
Channel Locks
Screwdriver
www.mirabelleproducts.com
Tape Rule
Tape Rule
Drill
Drill
© 2017 Ferguson Enterprises, Inc. 0817 502911