Blade Attachment; Installing The Adapter Plate - Hinkley CROFT Manual De Instrucciones

BLADE ATTACHMENT

INSTALLING THE ADAPTER PLATE

Fig. 1
10 | hinkley.com
Blades
Fiber Washer
Screws
Mounting Hub
(bottom of motor)
Adapter plate
Screws
WARNING: To reduce the risk of personal injury, do not bend the
blades while installing, balancing the blades, or cleaning the fan.
Insert the blade through the slot in the housing. Align the holes in the
blade and the fan motor assembly and secure with the blade attachment
screws and fiber washers.
Repeat this procedure with the remaining blades.
NOTE: Be sure the power is off before installing.
Remove one of the three screws on the mounting hub located
1
on the fan motor.
2
Loosen the other two screws. (Do not remove) (Fig. 1)
3
Install adapter plate to mounting hub.
Line up the two slotted holes with the two loose screws on the
4
mounting hub located on fan motor.
5
Re-install the third screw removed and tighten all three.