Test The Installation - Yakima LowRider MAX Manual De Instrucciones

TIGHTEN THE
FRONT TOWERS:
• Rotate the lever until it closes
with firm resistance.
• While tightening, apply
pressure on the tower to keep
it on the rail.
Repeat steps to
attach rear
towers and bar.
Measure equal
distance from front
towers.
SKS ® Lock Cores are optional.
Refer to Lock Core instructions for
installation.
1033347A-4/15
When tightening,
make sure the
towers grip the
factory rails
SECURELY.
(If the pads are not seated on the tower,
the claw may not seat to the rail.)
TEST THE
INSTALLATION:
Grab the bar near the
towers and pull up,
back and forth.
IF A TOWER SLIDES OR LIFTS AWAY FROM THE BAR,
repeat the tightening process until the tower is secure.
CROSSBAR SPREAD:
The distance between the Yakima
crossbars is determined by the accessories
you wish to carry. The Crossbar Spread
Table will tell you how much crossbar
spread your accessories require.
(Refer to your YAKIMA Dealer,
or go online at www.yakima.com)