Descargar Imprimir esta página

Eaton Metalux AP VT Serie Instrucciones De Instalación página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions – AP VT
Suspension Mount
5.
Attach V- bracket to each mounting clip by spreading
the ends of the V-bracket apart and then inserting the
legs into the holes in the side of the mounting clips.
(Figure 4)
Figurt 4.
6.
Secure mounting clips to housing recesses by firmly
pressing them into place until both sides of the clip
are secured. (Figure 5) Hang fixture from customer
supplied chain using V-brackets.
Figurt 5.
7 .
Release latches by pulling top of latch away from
housing (Figure 6). Remove lens and set aside.
Figurt 6.
2
EATON
IB519083EN
Installation Instructions
8.
Without touching LED boards, squeeze gear tray clips
inward and gently lower gear tray until it hangs from its
installation tethers. (Figure 7)
Figurt 7.
9.
Remove screw from center of driver enclosure door
and set aside. Squeeze both sides of the driver
enclosure and swing door open. (Figure 8)
Figurt 8.
10. Squeeze tabs of the clasp holding the flexible metal
conduit into the driver enclosure and pull the clasp
completely out of the knockout in the enclosure.
(Figure 9)

Publicidad

loading