Final Assembly - Metra 99-3012G-LC Instrucciones De Instalación

INSTALLATION
With the key in the off position:
1. Connect the 3012 harness into the 3012 interface, and then to the wiring harness in the vehicle.
2. Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Metra recommends using the proper mating adapter from Metra.
PROGRAMMING
Attention! If the interface loses power for any reason, the following steps will need to be
performed again.
1. Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note: If the radio doesn't come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
2. Turn the key to the off position, and then to the accessory position. Test all functions of the
installation for proper operation, before reassembling the dash.
6

FINAL ASSEMBLY

1. Secure the completed assembly to the dash using the factory screws.
2. Snap the radio trim panel over the completed assembly, then reassemble the dash in
reverse order of disassembly.
|
1.800.221.0932 MetraOnline.com