Kohler K-702010 Guia De Instalacion página 4

1. Install the Threshold
Measure the length of the shower opening for the door. Mark this measurement on the threshold.
The threshold should run the entire length of the opening.
Cut the threshold to the measured length with a miter saw or hacksaw. File the rough edges.
Locate the threshold on the receptor ledge with the flat edge towards the outside (dry side) of the
shower and mark the location. Apply silicone sealant to the edge underneath the threshold and
attach to the ledge. Temporarily secure the threshold with masking tape.
NOTE: Do not locate tape on the hinge side, where the side lite bracket will be mounted.
1011451-2-F
Threshold
Apply silicone sealant
under threshold edge.
4 Kohler Co.