Assembly; Assembling The Blow Pipe And Control Handle; Optional Equipment - Husqvarna 350BT Manual De Instrucciones

Assembling the blow pipe and
control handle
• Connect the blower and control pipe with the flexible
hose. Clamp both ends of the flexible hose in place.
Use the accompanying hardware.
1
3
1 Flexible hose
2 Control pipe
3 Clamp
4 Clamp
NOTE!
Lubricate the pipes a little to facilitate assembly.
• Fasten the handle holder to the control pipe and
tighten the knob on the holder. Please make sure to
align the handle holder with the convex of the control
pipe.
• Adjust the position and angle to achieve a comfortable
working position, and tighten.
350BT
• Use the clamp to fasten the cabling to the flexible
hose.
• Connect the straight pipe and pipe end. Push the
pipes together and turn them so they lock.
530BT
• Fasten the cabling at the centre of the hose using the
strap provided with the cabling.
• First, wrap the flexible hose with the strap. Start at the
bottom. Then run the strap through the hole in the
strap as shown in the figure. Please note that there is
a possibility of damaging the hose if the strap is
tightened too hard.

ASSEMBLY

2
4
Blow pipe
Assemble the intermediate pipe and the blow pipe. It is
possible to add more intermediate pipes if longer blow
pipes are required.

Optional equipment

(Not included in the box).
Handlebar
Disassemble the intermediate pipe. Disassemble the
knob from the holder and puch the holder on to the holder
pipe. Assemble the knob and tighten.
Assemble the intermediate pipe.
Flat nozzle
• If higher air speed is required, the round blow pipe is
replaced by the flat nozzle.
–
English 13