Additional Information - Cata Purifyer Instrucciones Para La Instalación, El Uso, El Mantenimiento

ADDITIONAL INFORMATION

FAQs
This section summarises the most common problems the appliance may encounter.
If you cannot solve the problem with the information below, please contact
customer service.
PROBLEM
The SENSOR ERROR warning
appears on the TFT display. The
purifier does not self-diagnose and
only works in manual mode.
The ENGINE ERROR warning
appears on the TFT display and the
purifier does not work.
The PRE-FILTER MAINTENANCE
warning appears on the TFT display.
The REPLACE HEPA H13 FILTER
warning appears on the TFT
display.
The display is frozen and does not
show the screens correctly.
The top controls are frozen.
POSSIBLE SOLUTION
• The sensor may sometimes take a few minutes
longer than usual to detect. Wait a few minutes until
it detects normally again.
• Check that the sensor detection grille is not wet or
covered by an object.
• If it does not respond, switch off the purifier, wait 5
seconds and switch it on again.
• If this does not solve the problem, contact the
technical service.
• Check that the power supply cable is correctly
connected.
• Check that the air inlet and outlet are not blocked or
covered by an object.
• Check that the purifier is installed on a flat, stable
surface.
• If it still does not work, switch off the purifier, wait 15
seconds and switch it on again.
• If this does not solve the problem, the engine is
possibly damaged. Contact the technical service.
• See the PRE-FILTER MAINTENANCE section of the
instruction manual.
• See the HEPA H13 FILTER MAINTENANCE section of
the instruction manual.
• Switch off the purifier and unplug it. Wait 15 seconds
and switch it on again.
• If this does not solve the problem, contact the
technical service.
• Switch off the purifier and unplug it. Wait 15 seconds
and switch it on again.
53