Technical Specifications - Johnson Controls VA9104-AGA-1S Instrucciones De Instalación

English

Technical Specifications

Product Codes
Power Requirements
Control Type
Input Signal
Feedback Signal
Motor Input Impedance
Running Torque
Travel Time
(for 90° of Rotation)
Rotation Range
Cycles
Audible Noise Rating
Electrical Connections
Mechanical Connections
Enclosure
Ambient Conditions
- Operating -20 to 60° C; 90% RH Maximum, Noncondensing
- Storage -30 to 65° C; 90% RH Maximum, Noncondensing
Fluid Temperature Limits
(Actuator and Valve Assembly)
- Water VG1205 and VG1805 Series Valves: -5 to +95 °C
- Steam Not Rated for Steam Service
Shipping Weight
Compliance
VA9104-AGA-1S
2.1 VA
Floating Control without Timeout
AC 24 V +25% / -20% at 50/60 Hz, SELV Class III
---
---
4 Nm
60 Seconds at 60 Hz
72 Seconds at 50 Hz
91° ±2°, CW or CCW
100,000 Full Stroke Cycles;
2,500,000 Repositions at Rated Running Torque
35 dBA Nominal at 1 m
1.2 m Polyvinyl Chloride (PVC) cable
Up to13 mm Diameter Round Damper Shafts, or 10 mm Square Damper Shafts
NEMA 2, IP 42
0.5 Kg
Johnson Controls, Inc., declares that these products are in compliance with the essential requirements and other relevant provisions of the
EMC Directive 2004/108/EC and Low Voltage Directive 2006/95/EC
IS_VA9104-AGA-1S / VA9104-IGA-1S / VA9104-GGA-1S_14-88360-2331_Rev. C_01 2011
VA9104-IGA-1S
AC 24 V +25% / -20% at 50/60 Hz
3.0 VA
Safety Extra-Low Voltage (SELV) Class III
ON/OFF and Floating Control With Timeout
with Timeout
---
200 ohms Nominal
4 Nm
60 Seconds at 60 Hz
72 Seconds at 50 Hz
This document is subject to change without notice
VA9104-GGA-1S
3.6 VA
Modulating
DC 0(2) to 10 V or 0(4) to 20 mA
with field furnished 500 ohm resistor
DC 0(2)...10 V Corresponds to input
span selection (DC 10V at 1 mA)
4 Nm
60 Seconds at 60 Hz
72 Seconds at 50 Hz
2