Brushless Electrical Micromotor - Side Panel (Optional) - Olsen INFINITY Guía De Operación

Selected gear ratio: 1:1
Rotation speed: 15 x 1000 = 15,000 rpm
To activate memory: press the desired Memory key (6). The display will show the speed and the LED (3) will
indicate the present transmission.
To record memory: select the transmission and adjust the speed of rotation to store. Press and hold one of
the Memory key (7) until the system emits 2 beeps, indicating that the memory has been recorded.
To save the second available memory repeat the same procedure.
To adjust the electrical micromotor water: use the water control knob (9) on the instruments control panel.

6.4.4 - Brushless Electrical Micromotor - Side Panel (Optional)

Before starting the operation, connect the
handpiece to the electrical micromotor (16).
To activate
propulsion/activation pedal (14) or the Manual
Start key (11). The On/Off indicator (2) will turn
blue.
To select a preset program: use the Program
key (8). There is 7 programs available, according
the table below:
The selected direction is shown on the display (1).
To record program: select program P1 or P2, then select the
desired gear ration and adjust the speed. Press and hold the Program key
(8) until the system save your settings.
To adjust speed: use the adjustment keys (13) to increase or decrease speed. Please see the table below
for speed range for each gear ration value:
To adjust the micromotor water: use the water control knob (15) on
the instruments control panel (section 5.4).
To access setup menu: press and hold the Setting key (12). Use the
Setting key (12) to select the desired option.
To adjust LED options: use the adjustment keys (13) to set the
parameter.
LED Off
To adjust pneumatic activation method: use the adjustment keys (13) to set the parameter. The selected
pneumatic activation method is shown on the display (6).
Micromotor performs speed according to
the pressure on the pedal (14)
Factor: x1.000
the rotation: press
The selected direction is shown on the display (5).
To select the gear ratio: use Gear Ratio key (10). There are the following
values available: 1:5, 1:1, 4:1, 10:1, 16:1 and 20:1.
The selected direction is shown on the display (4).
To change the rotation direction: use the Direction key (9).
The selected direction is shown on the display (3).
LED On
without delay
the
Forward
LED On
with 10s delay
When pedal (14) is pressed micromotor
performs the maximum speed adjusted
17
Reverse