Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.5a. In case of clogged nozzle
Clean nozzles and filters
Do not use metal instruments. Use a brush with nylon bristles clean and neutral
detergent.
5.6. Cylinder valve maintenance
DISASSEMBLING
• Remove the chamber from the cylinder.
• Remove the nuts (1) from the cylinder.
• Remove the cylinder (2).
• Loosen the bolts (3), and remove the cylinder body (4).
• Remove the valve seat (5) and loosen the valve (6).
• Clean or replace the parts that show wear.
ASSEMBLING
• Mount the valve (6) on the valve seat (7) and put into the cylinder (4) guided
by the groove.
• Mount the cylinder on the base (8) and fasten it with the screws (3).
• Install the assembly in the sprayers and fasten it with the nuts (1).
• Mounth the compensation chamber.
2
5.7. Triple rinse of empty agrochemicals containers
NOTICE: Even the containers considered empty contain chemical residues. There-
fore, discarding the containers without washing out the residues is extremely
dangerous to man, animals and environment. In the case of metal, plastic and
glass chemical containers, each container must be rinsed three times to ensure
the residues are completely removed. This manual describes how to make the
triple rinse in a correct, safe and effective way.
1.
Immediately after emptying the container, you must keep it with the
Clean nozzles with brush
6
5
7
4
8
3
1
1
opening upside down over the sprayer tank opening or over the bucket
that you are using to prepare the chemical mixture for at least 30 seconds,
until no residue is left in the container, when the drops are falling in long
intervals.
2.
Hold the container in the upright position and fill it with water up to 1/4.
For example: in a 1000 ml container, put 250 ml of water.
3.
Install the container cap and tight it enough to avoid leakage during the
agitation.
4.
Agitate the container strongly in all ways (horizontal and vertical), for ap-
proximately 30 seconds to remove the residues that are on the container
internal walls.
5.
Take the container cap off and carefully pour the rinse water into the spray
tank.
6.
Keep holding the container over the spray tank opening for approximate-
ly 30 seconds to the last drop.
7.
Repeat this operation twice more. This way, you complete the triple rinse.
8.
Make the plastic and metallic containers useless by piercing the container
bottom with a pointed instrument. This way, their labels are not damaged
for identification purposes.
5.8. Disposal of waste products
The elimination of waste resulting from the dismantling of equipment during ser-
vice, maintenance or end of life (disposal) should be carried out respecting the
environment, preventing pollution of air, soil and water. If necessary, the waste
should be stored in appropriate locations and then transported by qualified and
trained people and companies.
Disposal of used spray should be done at appropriate points and approved for
receiving such material. If there isn't an appropriate nearby site, please contact
the Customer attendance:
Address: Dr. Luiz Miranda, 1650, 17580-000 – Pompeia – SP – Brasil.
E-mail: atendimento@jacto.com.br
Home page: www.jacto.com
6. Critical Safety and Health Information
WARNING!
Read carefully the chemicals manufacturer's labels.
7/36
Publicidad
Capítulos
Tabla de contenido
