Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO PREPARE THE MACHINE FOR OPERATION
How To Install The Brushes Or Pad Drivers
To install the brushes or pad drivers on the machine,
follow this procedure:
1.
Turn the key switch "ON".
2.
Put the brush switch in the "UP" position.
3.
Turn the key switch "OFF".
4.
Go to the front of the machine.
5.
Unlatch right and left brush housings and remove them. See
fi gure #9.
6.
Put a brush or pad driver under the brush motor plate. See
fi gure #10.
7.
Align the lugs on the motor gimbal with the slots in the brush
gimbal.
8.
Pull the brush up until the gimbal locks.
9.
Repeat steps 6, 7, and 8 to install the second brush or pad
driver.
How To Remove The Brushes Or Pad Drivers
To remove the brushes or pad drivers from the machine, follow this
procedure:
1.
Turn the key switch "ON".
2.
Put the brush switch in the "UP" position.
3.
Turn the key switch "OFF".
4.
Go to the front of the machine.
5.
Push down on two sides of the brush or pad driver until the
gimbals release.
Clarke
®
Operator's Manual (EN) - FOCUS S28/L28/S33/L33/S38/L38 WB
ENGLISH
EN
Figure #9
Figure #10
Form No. 70851A - 19 -
Publicidad
Capítulos
Tabla de contenido
